Nintendo ds lite Case Change Instructions

Revealing the case in your Nintendo ds lite could be frustrating, but as far as injury to a Nintendo system goes, fixing a broken ds lite case is inexpensive. Unlike internal damage, which can renders it useless, a broken case could be replaced, preventing from the need to get a new unit. When you have broken the way it is on your own Ds lite, even so the system still works properly you are able to send the machine set for repair or you can perform it yourself.



Instructions

1. Cover your work surface with a soft covering as being a face towel. Lay the Nintendo DS faced down around the towel.

2. Peel the rubber pads on the back from the unit. If you possibly could’t get them with your fingers, you may use your little friend screwdriver to pry the pads up.

3. Take out the screws around the back with the unit. There must be four screws holding the device together: one who holds inside the battery from the lower right corner, one on the card slot and two on the left-hand side from the unit.

4. Remove the battery from your unit. Remove the screw within the battery compartment and pull off the top's the screw was holding constantly in place.

5. Lift the spine cover off the unit carefully once all the screws are already removed. Don’t pull too much, because the unit is attached by a few cables. Note the location where the cables are affixed to the back case and carefully pull the end with the cables to take out them from the back cover. jklzaeqc 1119

6. Unscrew the screws which have been holding the buttons for the front with the unit constantly in place. Hold up the black flap above the directional pad and pull the wire attached underneath the flap from the casing.

7. Detach the electricity indicator by pulling left on the wire while sliding the casing toward the suitable. The wire should slide away from case plus the bottom level on the front on the case should come free, leaving exactly the top, front part of the case in place.

8 . Slide the wire for the left side of the top 50 % of the situation from the casing. Lift the ring within the right hand side from the case. This certainly will expose four rubber pads round the back of the screen.

9. Peel away the rubber pads to show four screws. Remove the screws each and every corner from the screen.

10. Grasp the casing on both sides on the screen and slide the casing up from the unit. The truth should remain attached by just a wire. Pull the wire left and push the casing to detach the wire in the casing.

11. Return from the stages in reverse order to collect the newest Nintendo ds lite cases over the internal area of the unit.