Replace a DS Shell

The shell over a Nintendo DS bag would be the name given to an arduous plastic case that protects the leading base unit from the console. Should you drop the DSi, by way of example, the shell will absorb the shock from the fall and protect the principle unit from damage. These shells are produced by third-party manufacturers. If you want to customize the shell on the DSi, that can be done in a short while.



Instructions

1. Switch off your Nintendo DSi with all the console's "Power" switch.

2. Open the lid on your Nintendo DS case.

3. Make use of a screwdriver to get rid of all of the screws holding your existing DSi shell together. The volume of screws you must remove is determined by any type of shell that you are using. This typically number will be between 6 and 10 screws.

4. Pull the very best the main shell off of the bottom level. Each pieces will separate. Get rid of the two items of the shell and hang them aside. jklzaeqc 1102

5. Place your Nintendo DSi inside bottom 1 / 2 your new shell. The shell includes a compilation of joints that allow it to spread out and close and also the lid with the DSi. Line the lid track of the DSi shell. Place the top half the shell on the bottom half. This half also features a similar joints that permit it to spread out and close while using lid of the DS Repair Parts.

6. Utilize screws included with your shell and also the screwdriver to install the most notable 50 % of the shell to the bottom half. When both areas of the shell are connected, the shell is properly installed.