The way to Fix a Loose Nintendo DSi XL Screen

In the event the top 50 % of your Ds lite begins to sit too loosely, or refuses to lock into put in place its open position, the console's dsi xl case has probably become worn or damaged. Nintendo supply a generous warranty on its DS products, when you are outside this warranty, otherwise you relish an issue, it's possible to perform your personal repairs. Just about all hinge malfunctions inside Nintendo DS are due to a faulty shell that is damaged around the hinge, so the best fix is usually to transplant the hinge mechanism in to a new shell.



Instructions

1. Construct every aspect using a clean surface. Utilize the tri-wing screwdriver and Phillips screwdriver as appropriate to undo the seven screws holding the trunk of the bottom 1 / 2 your Ds lite in place. Gently pry the trunk off and remove it. jklzaeqc 1122

2. Use the Phillips screwdriver to undo a few screws holding saving money motherboard available. Carefully utilize the needle nose pliers to disconnect the screen and microphone cables and take away the motherboard. Reach around and push lightly around the Nintendo DS's bottom screen to pop the motherboard inapposite. Gently lift the motherboard outside the dsi xl cases.

3. Undo the small screw revealed by detaching the motherboard to detach the highest screen from the bottom. Pry away the rubber pads concealing the 4 screws for the front face on the top screen panel and employ the Phillips head screwdriver to unscrew these screws. Eliminate the front facing with the top screen.

4. Remove all inner aspects of the interior from the top panel. Remove all remaining aspects of underneath panel as well, placing them carefully aside to generate replacement easy. The touch screen is held with adhesive, so gently pry this away. Be aware of how all components of the hinge mechanism fit together, particularly the tiny wire loop that protects the cables in the hinge.

5. Fit the hinge mechanism in to the new dsi xl case ( http://www.vdealbox.com/dsi-xl-ll-accessories/dsi-xl-ll-housing-case-cover.html ), noting that each component is only going to fit if it is inserted correctly. Use channel lock pliers to press the hinge into place plus a screwdriver to tighten the hinge wish. Fit the opposite components in the top and bottom halves of the shell. Make use of a little bit of silicon adhesive to adjust to the end screen into place. Make use of a small dab in this same adhesive to hold the nut of the battery door in position. Replace all screws to perform shell replacement and hinge repair.